Honsberg LABO-D-I - Screw In Transmitter

Sensor Magnetic field sensor (magneto-resistive)
Pre-tensioned hall sensor
Inductive sensor
Detection
distance
Magnetic field
sensor
Depending on magnets
used, signal threshold
typ. 8 Gauss
(= 0.8 milliTesla), switching distances over 25
mm possible
Pre-tensioned
hall sensor
Typ. 0.5..2.5 mm
Inductive sensor Typ. max. 4 mm
based on 1 cm³ ST37
Metering range 0..10 kHz for hall sensor
0..1 kHz for inductive sensor
Measurement
uncertainty
±0.1 % measured value
Pressure
resistance
Pressureless application
Operating
temperature
0..+70 °C
(other temperatures available on request)
Storage
temperature
-20..+80 °C
Materials Housing CW614N nickelled
Sensor flap PA
Plug insert PC
Contacts CuZn, gold-plated
Supply voltage 10..30 V DC
with voltage output 10 V: 15..30 V DC
Power
requirement
< 1 W (for no-load output)
Output data: all outputs are resistant to short circuits and
reversal polarity protected
Current output: 4..20 mA (0..20 mA available on request)
Voltage output: 0..10 V (2..10 V available on request)
Output current max. 20 mA
Frequency output:
Transistor output "push-pull"
lout = 100 mA max.
Pulse output: Transistor output "push-pull"
lout = 100 mA max.
Pulse width 50 ms
Pulse/quantity is to be
stated
Display Yellow LCD shows
Operating voltage (LABO-D...I / U) or
Output status (LABO-D...F / C)
(rapid flashing = Programming)
Electrical
connection
for round plug connector M12x1, 4pole
Ingress protection IP 67
Weight approx. 0.02 kg
Conformity CE