Honsberg OMNI-P1 - Pressure Transmitter / Switch

Sensor ceramic cell with measuring bridge using
thick film technology
Process
connection
male thread G 1
/4 A, G 1
/2 A
(optionally with female thread)
Measurement
ranges and
Range* Overpressure**
Burst
pressure
pressure bar psi bar bar
resistance 0.. 1 0… 14,5 5 6
0.. 2 0… 29,0 5 6
0.. 5 0… 72,5 7,5 15
0.. 10 0… 145 15 30
0.. 20 0… 290 30 60
0.. 50 0… 725 75 150
0..100 0…1450 150 250
*Optional measurement ranges on request
All pressure values relative (differential
pressure to the environment)
**The pressure transmitters may be loaded
with the specified overpressure < 1 sec.
Measurement
accuracy
±1 % of final value;
plus 0.05 %/K at < 0 °C and > 60 °C
Repeatability ±0.5 % of full scale value
Dynamics measurement cycle 32 ms, display cycle
0.5 sec.
Working
temperature
-20..+70 °C
(with gooseneck max. 120 °C)
Storage
temperature
-20..+80 °C
Supply voltage 18..30 V DC
Power
consumption
< 1 W
Analog output 0/4..20 mA, 0/2..10 V via a 500 Ohm
resistance after 0 V
(impedance of the receiver > 100 kOhm)
Switching output transistor output "push-pull"
(resistant to short circuits and polarity
reversal)
Iout = 100 mA max.
Hysteresis adjustable, for Min-switch, position of the
hysteresis above the limit value, and for
Max-switch, below the limit value
Display backlit graphical LCD-Display
(transreflective), extended temperature
range -20..+70 °C, 32 x 16 pixels,
background illumination, displays value and
unit, flashing LED signal lamp with
simultaneous message on the display.
Electrical
connection
for round plug connector M12x1, 5-pole
Ingress protection IP 67
Materials
medium-contact
stainless steel 1.4571, ceramic Al2O3, FKM
Materials, nonmedium-contact
stainless steel 1.4305 (housing), hardened
mineral glass, POM (programming ring),
Samarium-Cobalt (magnet)