Honsberg OMNIPLUS-RRH-010...050 - Flow Transmitter

Measuring
principle
Magnet-equipped paddle wheel
Detection with Hall sensor
Nominal size DN 10 (OMNIPLUS-RRH-010)
DN 25 (OMNIPLUS-RRH-025)
Connection type Female thread G 3
/8, G 1
Male thread G 3
/8 A, G 1 A
Hose nozzle Ø11, Ø30
(other threads, crimp and plug-in connections, connections with constants or limiters on request)
Ranges 0.1…100 l/min
(see table „Ranges“)
Measurement
uncertainty
±3 % of reading
Media Water or other low-viscosity liquids
Pressure loss max. 0.5 bar
Compressive
strength
PN 100
Media temperature 0...+70 °C
Storage temperature -20...+80 °C
Materials
wetted with media
Housing CW614N nickel-plated
or 1.4305
Rotor PVDF with magnets,
epoxy resin
Bearings Iglidur X
Axle ceramics Zr02-TZP
Gaskets FKM
optional: NBR, EPDM
Supply voltage 18...30 V DC
Current
consumption
< 130 mA
(SIO mode, unloaded outputs)
IO-Link
specification
IO-Link revision
Bit rate
Minimum cycle
time
SIO mode
Port class
Block parameterization
Data storage
V1.1
COM2 (38400 bit/s)
20 ms
yes
A compatible
yes
yes
Analog output Current: 4...20 mA
0...20 mA
Voltage: 0...10 V
2...10 V
0...5 V
1...5 V
0.5...4.5 V
Switching outputs 2 transistor outputs push-pull,
parameterizable as NPN o.C.
Short-circuit and reverse polarity resistant
Iout = 100 mA max per output
Configurable on the device as
● Limit switch
● Frequency output
● Pulse output
● Signal output for preset counter
Display 1.2" graphic LCD (transflective)
128 x 64 pixels
backlight white,
red on alarm message
Electr. connection M12x1 circular connector, 5-pin
Protection class IP65 / IP67
Conformity CE