Honsberg HR1MV-0050G.E - Flow Meter / Switch / Indicator

Sensor analog hall sensor
Nominal width DN 32..50
Process
connection
female thread G 11
/4..G 2
(further process connections available on
request)
Metering range 2..220 l/min for details see
Qmax. to 250 l/min table "Ranges"
Tolerance ±3 % of the full scale value plus viscosity
variation
Pressure
resistance
PN 200 bar
Media
temperature
-20..+85 °C optionally -20..+150 °C
Ambient
temperature
-20..+70 °C
Media water, oils (gases and aggressive media
available on request)
Wiring see section "Wiring"
Supply voltage 18..30 V DC
Power
consumption
< 1 W
Analog output 0/4..20 mA, 0/2..10 V via a 500 OhmW
resistance after 0 V.
Switching values
S1+S2
PNP or NPN, selectable, 300 mA max. load
in total, programmable as min. value or max.
value, resistant to short circuits,
reversal polarity protected.
Display backlit graphical LCD-Display
(transreflective), extended temperature
range -20..+70 °C, 32 x 16 pixels,
background illumination, displays value and
unit, flashing LED signal lamp with
simultaneous message on the display.
Ingress protection IP 67
Electrical
connection
for round plug connector M12x1, 5-pole
Materials
medium-contact
Brass construction:
CW614N nickelled,
CW614N, 1.4310,
hard ferrite
DN 32..40: NBR
Stainless steel
construction: 1.4571,
1.4404, 1.4310, hard
ferrite PTFE-coated,
DN 32..40: FKM
Materials, nonmedium-contact
CW614N, PPS, glass
Weight see table "Dimensions and weights"
Installation
location
Standard: horizontal inwards flow; other
installation positions are possible; the
installation position affects the display,
metering and switching range.